5/20/2023 0 Comments I pilot remote battery indicator![]() Position the back of the remote case so that the Alignment Peg is towards the top when the remote is laying on a flat surface.Place the board with the battery facing down on the back of the remote case. Note that the alignment peg in the back of remote case must line up with the corresponding alignment hole in the circuit board.Leave the Keypad in place on the front of the remote. Begin by removing the board from the front of the remote case. Ensure Battery is snapped securely in place. ![]() Install the new battery with the positive (+) side of the Battery facing up and away from the Circuit Board.To remove the Battery, place the tip of a finger or thumb under the exposed edge of the Battery and pry it upwards.Separate the case halves to access the circuit board.Remove the four screws on the bottom of the remote case.Temporarily ground yourself by touching a grounded metal object in order to discharge any static electricity in your body.The steps below will walk you through replacing the battery. This audio pattern will occur each time the receiver powers up until aĬhanging the Battery in the CoPilot Remoteīoth the PowerDrive CoPilot Remote and the Terrova CoPilot Remote use a CR2032 coin cell battery. The receiver will emit a 2 second long beep indicating memory is empty. Release the Learn Button and the receiver will reboot.During this time the receiver audio will emit a warble sound, slowly transition to a constant beep and then shut off. Continue to hold the Learn Button down for 10 seconds.Press and hold the Learn Button and power up the CoPilot receiver by reconnecting the Power Cables, or by making sure that the breaker, if equipped, is "on.".Remove power from the CoPilot receiver by disconnecting the Power Cables, or by making sure that the breaker, if equipped, is "off.".The receiver will beep 4 times confirming that it has “Learned” the remote successfully. ![]() The receiver will emit a continuous tone. Using a small blunt object such as a pen or screwdriver, press and hold the Learn Button located on the side of the receiver.This will also work to "Learn" any remote if all remotes are erased from the receiver. Any additional remotes can be "Learned" using the following steps. ![]() Your receiver may learn up to ten remotes.
0 Comments
Leave a Reply. |